32DSSP03.B
2 - 10
CAUTION
Be certain wheelchair is clearly within perimeter of
platform and does not interfere with operation of rollstop.
d. RAISE PLATFORM - Push and hold UP button until platform rises and stops automati-
cally at floor level.
e. Release wheelchair brakes and carefully enter vehicle.
f. Refer to “Stowing Platform” section below to stow platform.
2. EXITING VEHICLE:
a. DEPLOY PLATFORM - Push and hold DEPLOY button until platform is completely un-
folded from vehicle and stops at floor level.
WARNING
VERIFY THAT PLATFORM IS AT VEHICLE FLOOR LEVEL AND
THAT FRONT ROLLSTOP IS UP AND LOCKED IN POSITION.
b. Carefully place wheelchair in center of platform, facing outward (away from vehicle),
and lock wheelchair brakes.
CAUTION
Do not stand on bridgeplate as platform lowers.
c. LOWER PLATFORM - Push and hold DOWN button until platform is at ground level
and front rollstop is fully lowered.
d. Release wheelchair brakes and carefully exit platform.
e. Refer to “STOWING PLATFORM” section below to stow platform.
3. STOWING PLATFORM:
a. If platform is at ground level, push and hold UP button until platform rises and stops
automatically at floor level.
b. Push and hold STOW button until platform folds completely into vehicle.
CAUTION
Be certain platform has stowed completely before attempting to close doors. To avoid
damage to doors, do not release STOW button until lift pump motor stops automatically.
c. Close vehicle doors if lift is not equipped with a power door operator. If equipped with
a power door operator, the vehicle doors will automatically close after platform is
stowed.
To Next Page
Loading...
Need help?
General
