must be inspected or assembled by someone experienced with bike mechanics prior to use. Proper
assembly and inspection of all nuts and bolts are vital for safety and for your warranty coverage as damages
due to improper assembly are not covered under warranty. Improper assembly of critical components could
lead to serious injury and/or death. Do not submerge your ebike in water as this may damage the electrical
and mechanical components of the ebike and could cause death, serious personal injury, and/or property
damage. Be aware that the speed at which you are traveling may be faster than you are used to, especially
when accelerating.
If you feel that the pedal assist, or brake levers are abnormally functioning, such as jerky acceleration, brakes
not stopping the bike etc. please stop using your ebike immediately and contact our Customer Support
Department or review our Support Library for troubleshooting steps.
1.3
Electrical
Safety:
Only use the charger supplied by Ride1Up and never tamper or modify the charger in any way. Do not
leave the ebike or battery plugged into a wall outlet unattended. Unplug the battery before leaving the bike
alone. The charger has been designed for a specific voltage and should not be tampered with in any way.
Always check that the outlet’s voltage is the same as that stated on the rating label. A charger that is suitable
for one type of battery pack may create a risk of fire when used with another battery pack; never use the
charger with another ebike or attempt to charge this product with a different charger than provided.
Before use, check the charger cord for signs of damage such as exposed wires or tears in the cable lining.
A damaged or entangled charger cord increases the risk of fire and electric shock. Keep the charger cord
at least 6ft away from hot surfaces and sharp edges. Do not handle the charger with wet hands as it could
cause death, serious personal injury, and/or property damage. Do not store or charge the ebike outdoors.
The charger must be removed from the socket before removing the battery, cleaning or maintaining the
ebike because this creates potential for electrical damage and/or injuries.
1.4
Brake
Safety:
Regularly check your brakes for signs of wear and tear and functionality such as a reduction in
breaking power. Before every ride, quickly test your brakes by walking next to the ebike and engaging the
brakes assuring they are properly working. Visibly check your brakes to ensure there is no damage such as
cracks and breaks. Failure to do so could cause death, serious personal injury, and/or property damage.
Any worn parts must be repaired or replaced immediately. Be careful while getting used to the brakes. Never
brake with only your front brake. Practice emergency stops in a place clear of traffic until you are comfortable
controlling your ebike. Wet weather reduces your braking power and the grip of the brakes. Reduce your
speed and be aware of longer stopping distances when cycling in wet conditions. Braking on unpaved
surfaces will differ. Be sure to practice braking on different surface types. Ensure that braking
To Next Page
