To Next Page
M
Michelle TurnerJul 26, 2025
Why are threads tearing on my RIDGID Industrial Equipment?
- MMichael HarrisJul 26, 2025
Torn threads on RIDGID Industrial Equipment can occur due to several reasons. It might be caused by damaged, chipped, or worn-out dies, in which case you should replace them. Using incorrect or insufficient cutting oil can also lead to this problem; ensure you're using only RIDGID® Thread Cutting Oil and that the oil reservoir is full. Dirty or contaminated oil requires replacement with fresh RIDGID Thread Cutting Oil. Additionally, misalignment between the die head and pipe, using improper pipe (recommend black or galvanized steel pipe), pipe with a wall that's too thin (use schedule 40 or heavier pipe), an improperly set die head (adjust it to the proper thread size), or a carriage that doesn't move freely on the rails (clean and lubricate them) can all contribute to torn threads.
General
