RIDGID RD80770 - Page 11

11
ASSEMBLY
Spray
waNd
trIGGer
haNdle
GrOOVed
GrIppING
Surface
cONNectOr
Fig. 5
INjectION
hOSe fIttING
INjectION
hOSe
Fig. 7
CONNECTING THE HIGH PRESSURE HOSE TO
THE TRIGGER HANDLE
See Figure 6.
n Remove the high pressure hose from the storage bag
and uncoil the hose.
n Pull back and hold the quick-connect collar on the high
pressure hose. Insert the inlet coupler on the trigger
handle into the collar.
n Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
quIck-cONNect
cOllar
hIGh
preSSure
hOSe
INlet
cOupler
Fig. 6
ATTACHING INJECTION HOSE
See Figure 7.
Before detergent can be used with this machine, the injection
hose must be attached.
n Remove the clear injection hose. Uncoil the hose.
n Push the open end of the injection hose securely over
the fitting.
n Place the filtered end of the injection hose in the bottle
of detergent.