Riello 568 M - A Appendix

To Next Page

To Previous Page

20063667

Appendix - Accessories

Long head kit

LPG kit

Continuous purging kit

Air suction kit

Software diagnostics kit

Gas trains in compliance with EN 676

Please refer to manual.

A Appendix - Accessories

Burner

Standard length

(mm)

Long head length

(mm)

Code

RIELLO 40 FS15 120 280 3000873

Burner Code

RIELLO 40 FS15 3000885

Burner Code

RIELLO 40 FS15 3010094

Burner Code

RIELLO 40 FS15 20159751

Burner Code

RIELLO 40 FS15 3002719

Main Page

Table of Contents3
Information and General Warnings5
Information about the Instruction Manual5
Introduction5
General Dangers5
Other Symbols5
Delivery of the System and the Instruction Manual6
Guarantee and Responsibility6
Safety and Prevention7
Introduction7
Personnel Training7
Technical Description of the Burner8
Burner Designation8
Models Available8
Burner Categories - Countries of Destination8
Technical Data9
Maximum Dimensions9
Firing Rate10
Test Boiler10
Commercial Boilers10
Correlation between Gas Pressure and Burner Output10
Burner Description11
Burner Equipment11
Control Box (RMG88.62C2)12
Installation13
Notes on Safety for the Installation13
Instructions to Avoid Burnout or Bad Combustion of the Burner13
Handling13
Preliminary Checks14
Control of the Supply14
Control of Burner Characteristics14
Operating Position14
Securing the Burner to the Boiler15
Hinge Installation15
Positioning the Probe - Electrode15
Combustion Head Adjustment16
Air Damper Adjustment16
Gas Feeding17
4.10.1 Gas Feeding Line17
Gas Train17
4.10.3 Gas Train Installation18
Electrical Wiring19
4.11.1 Notes on Safety for the Electrical Wiring19
4.11.2 Fixing the Electric Cables19
4.11.3 Ionisation Current19
4.11.4 Standard Wiring Diagram20
Electrical Wiring with Valve Seal Control (DUNGS VPS 504)20
Start-Up, Calibration and Operation of the Burner21
Notes on Safety for the First Start-Up21
Adjustments Prior to Ignition21
Combustion Adjustment21
Air Pressure Switch21
Operation Sequence of the Burner22
Start-Up Programme Visual Diagnostics22
Normal Operation / Flame Detection Time22
Maintenance23
Notes on Safety for the Maintenance23
Maintenance Programme23
Maintenance Frequency23
Safety Test - with Gas Ball Valve Closed23
Checking and Cleaning23
Safety Components24
Opening the Burner25
Faults - Possible Causes - Solutions26
Tracing the Causes of the Malfunctioning26
Control Box Reset26
Visual Diagnostics26
Software Diagnostics26
A Appendix - Accessories30

Riello 568 M - A Appendix - Accessories

Table of Contents

Related product manuals