Riello AMW P - Vertical Deflector and Ventilation Mode; Sleep Function Operation

USE
14
A Cooling and Dehumidification mode
B Heating Mode
C Smart mode
D Initial position
A
B
C
D
— work
— select required position
Each press will select a different position.
When selecting
, position changes automatically according
to preset strategies.
9
When room humidity is high, condensate might form on the
deflector during operation in Cooling and Dehumidification
mode. In this scenario, if deflector is kept in vertical position
for a long time
, condensate could drip onto the objects
below.
9
Do not set under the equipment any objects susceptible to
get damaged in contact with water.
9
When climate control system is turned off, the horizontal
deflector will close automatically.
0
Do not manually move the deflector.
Vertical motorised deflector
The vertical motorised deflector controls the horizontal air flow
by setting a preferred outlet tilt or activating automatic opera-
tion (not available on AMW ST).
Set required deflector position as follows:
A Initial position
A
— work
— select required position
Each press will select a different position.
When selecting
, position changes automatically according
to preset strategies.
0
Do not manually move the deflector.
Ventilation mode
The Fan mode allows the user to turn on only the fan, so as to
recirculate and filter ambient air.
•
Activation
— press
FAN MODE
Remote control display shows and temperature value will go
off.
9
The equipment will operate at selected ventilation speed.
9
During operation in Ventilation mode, automatic sped can-
not be selected.
•
Switch-off
— press
FAN MODE
Remote control display no longer shows .
Sleep function
The Sleep function allows user to select a time period through-
out which the equipment will change reference ambient tem-
perature: