Riello AMW P - Health Air Flow Function; Anti-freeze Function

USE
15
A Sleep function on
B Sleep function end and unit switch-off
C Set temperature
h Hours passed since function activation
+ 1 °C
+ 1 °C
C
A
1h 2h 8h
B
— increasing it in Cooling and Dehumidification mode
A Sleep function on
B Sleep function end and unit switch-off
C Set temperature
h Hours passed since function activation
- 2 °C
- 2 °C
+ 1 °C
C
A
1h 2h 5h 8h
B
— decreasing it in Heating mode
9
In Smart mode: depending on the operating mode selected
by the programme.
9
In the Sleep function, fan will decrease its set speed by one.
•
Activation
— press
Remote control display shows .
•
Switch-off
— press
Remote control display no longer shows .
9
If the Timer function for automatic stop is already pro-
grammed, the Sleep function cannot be turned on.
Health air flow function
The Health air flow function sets the horizontal motorised de-
flector so as to avoid aiming the air flow directly at persons.
•
Activation
— press
Remote control display shows .
This setting is recommended for Cooling mode.
Change deflector position as follows:
— press
Remote control display shows .
This setting is recommended for Heating mode.
•
Switch-off
— press
the deflector goes back to the position it had prior to function
activation.
9
With Health air flow function on, horizontal deflector posi-
tion cannot be changed.
9
When room humidity is high, condensate might form on the
deflector during operation in Cooling and Dehumidification
mode. In this scenario, if deflector is kept in vertical position
for a long time
, condensate could drip onto the objects
below.
9
Do not set under the equipment any objects susceptible to
get damaged in contact with water.
Anti-freeze function
In case of long periods away during winter time, the Anti-freeze
function maintains the room at a temperature sufficient to avoid
freezing (not available on AMW ST).
The Anti-freeze function can be turned on in the following
modes:
— Heating
•
Activation
— press