Doc-0091350 Rev. 0
HELIOTERM INVERTER
PT
Avisos preliminares
Estas instruções são parte integrante do manual do
aparelho no qual o KIT é instalado. Consulte este manual
para as ADVERTÊNCIAS GERAIS e REGRAS FUNDAMENTAIS DE
SEGURANÇA.
CPD 35 - PAINEL DE COMANDO DE PAREDE
Versões
Códigos
20116410
CPD 35 - Painel de comando de parede
Em algumas partes do manual são utilizados os símbolos:
ATENÇÃO = para ações que exigem cautela especial
e preparação adequada.
PROIBIDO = para ações que não devem
absolutamente ser executadas.
O controlo remoto de parede é um termóstato eletrónico
(equipado com sonda de temperatura opcionalmente
remotizável num dos ventiloconvectores ligados ao
mesmo) com a possibilidade de controlo de um ou mais
aparelhos (até um máximo de 30) equipados com controlo
eletrónico de remotização.
Instale o controlo remoto de parede longe de portas
e/ou janelas e de fontes de calor (radiadores,
ventiloconvectores, fogões, luz solar direta), em paredes
internas e a uma altura de cerca de 1,5 m acima do
pavimento.
O controlo remoto de parede é fornecido já montado,
portanto, antes da montagem na parede, as duas partes
devem ser separadas, desengatando os dois dentes
salientes na parte superior (ref.A).
Em seguida, utilize a base do controlo (ref.B) para marcar
os pontos de xação na parede (utilize dois furos opostos).
Em seguida, realize as seguintes operações:
fure a parede;
passe os cabos elétricos através das janelas presentes
na base;
xe a base do controlo à parede, utilizando os parafusos
e buchas adequadas;
efetue as ligações elétricas e feche o controlo, tendo o
cuidado de não esmagar os condutores.
Montagem e ligações do painel de controlo
remoto de parede
EN
Preliminary instructions
This instruction booklet is an integral part of the manual
of the device on which you install the kit. In that manual,
please refer to the WARNINGS and the BASIC SAFETY RULES.
CPD 35 - CONTROL PANEL WALL MOUNTED
Versions
Codes
20116410
CPD 35 - Control panel wall mounted
The following symbols are used in this publication:
WARNING = actions requiring special care and
appropriate training.
DO NOT = actions that MUST ON NO ACCOUNT be
carried out.
The wall-mounted is an electronic thermostat (tted with
temperature probe optionally remotable in one of the
fancoils connected to it) with the possibility of controlling
one or more cooler-convector/cooler-radiators (up to
a maximum of 30) equipped with electronic control for
allowing remote control.
Install the wall-mounted remote control away from doors
or windows and sources of heat (heaters, convectors,
stoves, direct sunlight), on internal walls at a height of
about 1.5 m from the oor.
The wall-mounted remote control is already assembled
in the package, therefore before mounting them the
two parts must be disconnected by unhooking the two
protruding notches on their back (ref. A).
Use the base of the control (ref. B) to trace the xing point
on the wall (use the two opposite holes).
Then proceed with the operations below:
drill the holes in the wall;
route the electric wires through the windows on the
base;
x the base of the control to the wall using suitable
plugs;
perform the electrical connection and then close the
control paying attention not to crush the conductors.
Fitting and connecting the wall-mounted
remote control panel