Riello Multi Switch - Usage and Operating Conditions; Packaging and Storage

- ENGLISH -
Multi Switch – User’s Manual
________________________________________________________________________________________________________
11
8 USAGE AND OPERATING CONDITIONS
Use
The Multi Switch has been designed to use a 180/265 Vac single-phase 50/60Hz power supply.
In line with current regulations, only use the cables that have been supplied with the machine. The power supply
socket must be easily accessible to the operator.
The purchaser of the machine undertakes to use the Multi Switch in suitable operating conditions, and to use it in the
manner for which it was designed, taking into account the use, importance, and the functions (whether secondary or
indirect) of the equipment that is being monitored. The Manufacturer is not responsible for indirect damage.
WARNING: The Multi Switch must be connected to earth when in use.
ATTENTION! A soft damp cloth may be used to clean the outside of the machine (always with the system
disconnected from the mains power supply and users).
Do not use any type of solvent as this may damage the external finishing of the machine.
ATTENTION! The Multi Switch has been designed exclusively for professional use.
NOTE: These instructions may be modified by the wiring regulations in force in the country where the Multi Switch is
purchased.
Operation
The Multi Switch has been designed exclusively to operate indoors. It is advisable to install it in areas where no
inflammable liquids or gases, or other harmful or noxious substances, have been stored.
9 PACKAGING AND STORAGE
Packaging
The packaging is designed to protect the equipment during normal transport conditions.
It is strongly advisable to conserve the packaging in a safe place in case the equipment needs to be taken to a
service centre for maintenance or repair in the future.
It is important to check that the Multi Switch has not been damaged during transportation.
If the machine has been damaged in transportation return it immediately (no later than eight days from the date of
receipt).
ATTENTION!: The packaging materials may be a source of danger if left within the reach of children, etc…
Storage
Store the Multi Switch in a cool dry place in a horizontal position away from atmospheric agents.
Avoid knocking or bumping the casing as this might cause damage to the mechanical and electrical components of
the machine. Do not place other items on top of the Multi Switch if the total combined weight is five (5) times greater
than the machine itself.
Other items supplied
Along with the Multi Switch, the following items are also supplied:
 Two fasteners for fastening the Multi Switch to the rack;
 Two SCHUKO-IEC (16A) cables for the two input sockets;
 Four IEC-IEC (10A) cables for the output sockets;
 A serial communication cable pin-to-pin DB9 F/M;
 This user manual;