Chapter 1 Quick Guide RIGOL
DG800 User's Guide 1-13
2. Up and Down Scroll Bar
Prompts you to move up and down with your fingers on the screen to view and
set parameters.
3. Information Setting
: opens the Store interface.
: opens the Utility interface.
: performs the channel copy function.
: performs the screen print operation.
4. Right Arrow
Prompts you to slide right on the screen to switch to the waveform selection
interface.
5. Status Bar
: indicates that the front-panel keys and the screen are locked.
: indicates that the beeper is disabled.
: indicates that the instrument is in programming-controlled mode.
: indicates that the instrument has been successfully connected to the local
area network by using the network cable.
: indicates that a USB storage device is found.
6. Waveform
Displays the currently selected waveform of each channel.
7. Interface Label
Displays the label of the current interface.
8. Frequency
Displays the frequency of the current waveform of each channel. Tap the Freq
parameter input field to modify the parameter with the pop-up numeric keypad.
You can also use the arrow keys and the knob to modify the parameter.
9. Amplitude
Displays the amplitude of the current waveform of each channel. Tap the Ampl
parameter input field to modify the parameter with the pop-up numeric keypad.
You can also use the arrow keys and the knob to modify the parameter.
10. Offset
Displays the DC offset of the current waveform of each channel. Tap the Offset
parameter input field to modify the parameter with the pop-up numeric keypad.
You can also use the arrow keys and the knob to modify the parameter.
To Next Page
Loading...
