Rigol DL3000 Series Programming Guide

Chapter 5 Appendix RIGOL
DL3000 Programming Guide 5-1
Chapter 5 Appendix
Appendix A: Default Settings
Note*: These parameters will not be affected by the default setting operations.
You can restore the instruments to factory defaults by doing either of the following operations:
 Send the
*RST command.
 Press Utility  System  Power-on to select "Default", and then when you power on the
instrument the next time, it will restore to its factory default settings.
Channel Parameter
CC
Current 0 A
Range 6 A
Slew Rate 0.001 A/μs
Starting Voltage (Von) 0 V
V_Limit 155 V
C_Limit 70 A
CV
Voltage 0 V
Range 150 V
V_Limit 155 V
C_Limit 70 A
CR
Resistance 2 Ω
Range 15 kΩ
Starting Voltage (Von) 0 V
V_Limit 155 V
C_Limit 70 A
CP
Power 0 W
V_Limit 155 V
C_Limit 70 A
Con
Range 6 A
A_Level 4 A
B_Level 1 A
Rising slew rate 0.001 A/μs
Falling slew rate 0.001 A/μs
Period 1 kHz
Duty 50%
Trigger Source TRAN
Pul
Range 6 A
A_Level 4 A
B_Level 1 A
Rising slew rate 0.001 A/μs
Falling slew rate 0.001 A/μs
Width 2 s

Rigol DL3000 Series Specifications

General

Brand	Rigol
Model	DL3000 Series
Category	Measuring Instruments
Language	English