Rigol DP800 Series Calibration Guide

RIGOL Chapter 1 Calibration Notices
1-2 DP800 Calibration Guide
To Acquire the Calibration Service
RIGOL does not recommend manual calibration by users. If calibration is required,
please contact RIGOL customer service department or the local distributor.
Recommended Test Devices
It is recommended that you use the test devices listed in the table below or other test
devices whose performance specifications satisfy the “Performance Requirement”
listed in the table below for calibration.
Table 1-1 Recommended Test Devices
Device
Performance Requirement
Recommended
Digital Multimeter 6
1
/
2
RIGOL
DM3068
Test Lead
Connect the output terminals of
DP800 and the input terminals of
the multimeter
__
Short Circuitor
Short-circuit the positive terminal
(+) of the channel output
terminals and positive terminal
(S+) of the Sense terminals;
short-circuit the negative terminal
(-) of the channel output terminals
and negative terminal (S-) of the
Sense terminals
__
Test Notices
For optimum performance, all procedures should comply with the following
recommendations.
1) Make sure the environment temperature is stable and between 18℃ and 28℃.
Ideally, the calibration should be performed at 23℃±1℃.
2) Make sure the environment relative humidity is less than 80％.
3) Make sure that the instrument has been warmed up for at least 30 minutes
before the calibration.
4) Keep the test cables as short as possible and make sure that the impedance of
the cable is consistent with the requirement.

Rigol DP800 Series Specifications

General

Brand	Rigol
Model	DP800 Series
Category	Power Supply
Language	English