Rigol DP811 User Manual

Chapter 3 Remote Control RIGOL
DP800 User’s Guide 3-1
Chapter 3 Remote Control
DP800 series power supply can be controlled remotely via the following two modes.
User-defined programming
Users can program and control the instrument by using the SCPI (Standard
Commands for Programmable Instruments) commands. For more information about
the commands and programming, refer to the
DP800 Programming Guide .
Use PC software
Users can use the PC software to send commands to control the instrument remotely.
Ultra Sigma of RIGOL is recommended. You can download Ultra Sigma from RIGOL
official website (
www.rigol.com
).
This power supply can communicate with PC through USB, LAN, RS232 and GPIB
(with the USB to GPIB interface converter provided by RIGOL) instrument buses.
This chapter will give a detailed introduction of how to use Ultra Sigma to control
the power supply remotely through various interfaces.
The contents of this chapter are as follows:
 Remote Control via USB
 Remote Control via LAN (option)
 Remote Control via GPIB (option)
 Remote Control via RS232 (option)

Rigol DP811 Specifications

General

Brand	Rigol
Model	DP811
Category	Power Supply
Language	English