Chapter 2 Front Panel Operations RIGOL
DP800 User Guide 2-55
knob and left/right arrow key to input the desired address. This setting is stored
in the non-volatile memory and the instrument will load the server address set
automatically at the next power-on if DHCP and Auto IP are set to "Off".
9. Default
Press Def Cfg and the prompt message "Restore LAN to default?" will be
displayed; press OK to restore the network parameters to default values. At this
point, the DHCP and auto IP configuration modes are enabled and the manual IP
configuration mode is disabled.
10. Current Setting
Press Cur Cfg to view the MAC address, current network parameters and
network status information of the instrument.
11. Apply the Setting
Press Apply to apply the network parameters currently set.
Note: After setting the network parameters, you need to press Apply to apply the
network parameters currently set; at this point, the new settings take effect.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
