Chapter 2 Functions of the Front Panel RIGOL
VNA User Guide 2-43
Peak
The peak search function enables the marker to move to the specific signal peak
point, and then in combination with the function of Delta marker, it can provide a
powerful analysis capability.
Peak Search
Performs the peak search function. Searches for the maximum value on the trace and
marks it with a marker.
Next Peak
Searches for and marks the peak whose amplitude on the trace is next to that of the
current peak.
Next Peak Right
Searches for and marks the nearest peak which is located at the right side of the
current peak.
Next Peak Left
Searches for and mark the nearest peak which is located at the left side of the
current peak.
Minimum Search
Searches for and marks the peak with the minimum amplitude on the trace.
Cont Peak
Enables or disables continuous peak search. By default, it is Off.
When it is enabled, after finishing each sweep, the analyzer will automatically
execute one peak search operation to track the measurement signal.
Remarks:
When the Cont Peak function is on, if the current marker is off, set the marker to
Position mode, and then execute the peak search operation.
To Next Page
Loading...
