Need help?Do you have a question about the ring Floodlight Cam Wired Plus and is the answer not in the manual?
General| Type | IP security camera |
|---|---|
| Luminous flux | 2000 lm |
| Remote viewing | Yes |
| Color temperature | 3000 K |
| Placement supported | Outdoor |
| Connectivity technology | Wired |
| Form factor | - |
| Mounting type | Wall |
| Product color | Black |
| Ethernet LAN | No |
| Wi-Fi standards | 802.11b, 802.11g, Wi-Fi 4 (802.11n) |
| AC input voltage | 100/240 V |
| Power source type | AC |
| Operating temperature (T-T) | -20 - 50 °C |
| Number of lenses | 1 |
| Total megapixels | - MP |
| Maximum resolution | 1920 x 1080 pixels |
| Supported video modes | 1080p |
| Audio system | 2-way |
Weight and Dimensions| Depth | 179 mm |
|---|---|
| Width | 246 mm |
| Height | 299 mm |
Open the Ring app and select 'Set Up a Device' to begin configuration.
Scan the unique device code to identify your Ring device for fast setup.
Warnings for electrical shock, fire risk, and proper grounding during installation.
Note the requirement for a 4" round UL listed weatherproof electrical box.
Turn off power to the circuit at the breaker before starting installation.
Adjust light fixtures and camera position based on mounting location.
Safely remove the old floodlight and disconnect its wires.
Select the correct screws and attach the metal mounting bracket to the junction box.
Feed power wires and secure the plastic mounting plate to the metal bracket.
Use the nylon strap to temporarily hang the fixture onto the mounting plate hook.
Connect the Floodlight Cam's green, white, and black wires using wire nuts.
Consult an electrician if unsure about wire identification or connection.
Secure the fixture with hex nuts and apply weatherproof sealant.
Turn power back on at the circuit breaker after installation.
Follow in-app instructions to complete the Floodlight Cam setup.
To Next Page
