ring Retrofit Alarm Kit User Manual

12
• Next, pull the battery tab to power on the Retrofit Alarm Kit. It will
power on and begin to communicate with your Ring Alarm.
• The Ring app will prompt you to configure the device. You can give it a
name and add it to a room.
8. Move the Retrofit Alarm Kit to the place where it will be installed near the
wired alarm panel. This may be in a basement or closet. Do not mount it on
the wall yet.
9. Run the communication test in the app to ensure that the Retrofit Alarm Kit
can send a signal to the Ring Alarm Base Station.
• If you see the light flash green, it passed the test.
• If you see the light flash red, the test failed.
• If the communication test fails, you should repeat the test. If it continues to
fail, you can add a Range Extender between the Retrofit Alarm Kit and the
Base Station in order to strengthen the Z-Wave signal. You can also try moving
your Ring Alarm Base Station closer to the alarm panel.
10. When the communication test passes, the Ring app will show all zones as
Available or Ready to Test, and you are ready to move on.

ring Retrofit Alarm Kit Specifications

General

Connectivity	Z-Wave
Operating Conditions	32°F to 120°F (0°C to 49°C)
Mobile App	Ring App (iOS and Android)
Voice Control	Works with Alexa
Color	White
Compatibility	Works with Ring Alarm security system
Power Source	Hardwired
Battery Backup	Requires Ring Alarm Base Station (sold separately)