Page 14
GT490X
User Manual
6) Enter the code you require (codes may be 4,
5 or 6 digits) followed by YES.
(Entering 000000 will delete an existing code).
Note: If the code already exists, an error will be shown,
choose another code and return to step 6
7) The display will show:-
(not if user 1 is being programmed).
Press NO until the require level of code is shown
(Refer to page 3 for code level details. Refer to Advanced Code Programming
for details for User level of Control).
8) Press YES.
The display will show, for example:-
Code Groups are only used in conjunction with
controlling outputs. (See Advanced Code
Programming section for details).
9) Press YES. The display will show:-
This determines if using this user code to Set or
Unset the system will trigger the Vo-Comm.
(For more details on Vo-Comm please refer to the
Vo-Comm section). Press NO until the setting you
require is displayed (YES or NO).
Note:
The Vo-Comm will need to be programmed in
order for this option to work (please refer to the
Vo-Comm section in this manual).
10) Press YES. The display will show:-
If you wish to accept the name shown press
YES and jump to step 13.
Or
If you wish to change the name shown press
NO, the display will show:-
11) You may now enter up to nine characters for
the user name using the layout shown on the
following page for the allocation of characters.
User 02 Name
=User 02
Code Group
= None ok?
VoComm Trigger
= On Ok ?
User 2 Name
>-
Code Type . . -
= Master ok?
To Next Page
Loading...
