Page 13
GT490X
User Manual
Programming User Codes (Master code only)
The charts on pages 2 & 37 should be completed by the engineer/user for future
reference of what codes have been allocated on your system. Under no
circumstances should the actual user code be written down.
If your installation company has given you keyswitches for the operation of your
system some user codes may have been reserved for use by these keyswitches.
If your engineer has indicated (see pages 2 & 37) that some of the user
numbers on your system have been reserved you should not use them
whilst programming user codes. If you do so your system may be
adversely affected.
1) With the display showing:-
2) Enter a Master Code, the display will show:-
3) Press NO five times, the display will show:-
4) Press YES, the display will show:-
5) Enter the user number (1 to 15 that you
wish to program followed by YES, the
display will show:-
01 JAN 18 : 58 : 01
Do you want to . .
SET the System ?
Do you want to . .
Prog. USER CODES ?
Enter User No. - -
(1- 15) Then YES
Now Enter Code . .
- - - - - - Then YES
To Next Page
