Page 1/3
RZ series TECHNICAL BULLETIN
ISSUE NO. RZT-016
Issued By Overseas Technical Sec., Riso Kagaku Corp.
MODEL: RZ 2/3 Series DATE : 10-Mar.-05
Data Category
Field Modification Trouble Shooting General Information Safety Advice
Our Ref.: AZ1-0904/ 0818/ 0814/ 0811
SUBJECT: Master Disposal Jam
Brief:
Master disposal jam will be occurred if the master disposal box is set incorrectly.
To improve setting of the Master disposal box, relative parts have been changed.
Phenomenon:
Disposed master wrapped up on the Transport Roller lower.
Cause:
The Ribs of the Master disposal box do not fit with the Transport roller lower by following
causes.
1. Stay B is bended upward and prevents the box from sets in smoothly.
(See "Countermeasure 1" on the next page.)
2. Side rib on the master disposal box scrape against side flame of Master disposal flame.
(See "Countermeasure 2" on the next page.)
3. Incorrect setting of master disposal box.
(See "Countermeasure 3" on the next page.)
Disposed master
Correct setting
Incorrect setting
Rib on the Master disposal box
Some gap exists
Transport roller (Lower)
Disposed master wrapped up
To Next Page
Need help?
General
