Riso SF9 Series - [Advanced] Tab

Chapter 2 Working with the Printer Driver
53
Chapter 2 Working with the Printer Driver
53
[Advanced]Tab
3
1
2
5
6
7
8
9
0
a
b
4
1
 Printspeed
High Speed
1
2
 Printdensity
3
 Intervalprinting
2
4
 Inksaving
5
 Copies
6
 AutoProcess
7
 Output
2 3
8
 Programprinting
2
9
 Outputreversal
0
 IDprint
2
ID
a
 ActivatetheCondentialmodeafterjobcompletes
b
 Outputthedataafterinitializingprinter
1
Not displayed in the SF5x3 Series.
2
Not displayed in the SF5 Series.
3
The settings are made depending on the settings in the [Basic] tab. (
A
42)
1
Printspeed
Selects the print speed of the printer from 5 levels.
If it remains [Open], the original is printed at the speed set on the printer side.
HighSpeed
C
Not displayed in the SF5x3 Series.
Print at high speed (150ppm).
2
Printdensity
Selects the print density of the printer from 5 levels.
If it remains [Open], the original is printed at the density set on the printer.
3
Intervalprinting
C
Not displayed in the SF5 Series.
By allowing the printer to skip a paper feeding during printing, the ink has time to dry, preventing it from leaving marks
on the back of the next sheet.