To Next PageTo Next PageWhat to do if open button is pressed and the RITE-HITE Protecdor 8000CL closes?
If the open button is pressed on your RITE-HITE Garage Door Opener and the door closes instead of opening, the issue might be due to reversed phasing. To resolve this, reverse the wires connected to terminals V and W.
How to fix PLC run light if it is off on RITE-HITE Garage Door Opener?
If the PLC run light is off on your RITE-HITE Garage Door Opener, make sure the PLC is in the "Run Mode" by opening the PLC cover door and switching to "Run". If the switch is already in run mode, or if the "Run" light is off with an Allen Bradley PLC, you may need to contact your local RITE- HITE DOORS, INC. representative to reprogram the door.
How to align photoeyes on RITE-HITE Protecdor 8000CL?
If the photoeyes on your RITE-HITE Garage Door Opener are not aligned properly, turn the adjustment screws or loosen the mounting brackets to realign them.
What to do if the brake is not functioning properly on RITE-HITE Protecdor 8000CL Garage Door Opener?
If the brake on your RITE-HITE Garage Door Opener is not functioning properly, check the following: * Output Y7 MUST GO OFF when the door is fully open or closed. * Contactor MUST BE PULLED IN when the door is running or the open button is pressed. * Brake wiring at terminals B1 & B2 and plug in connections. * The brake rectifier should put out 90-110VDC. * Brake will have 350 ohms on normal readings (must be checked after the rectifier). Also, inspect the air gap, referring to Page 19 for adjustment procedures. If you find a faulty contactor or F1 fuse, replace it.
General| Brand | RITE-HITE |
|---|---|
| Model | Protecdor 8000CL |
| Category | Garage Door Opener |
| Language | English |
Detailed guidance for securely mounting the sideframes to the wall opening.
Guides the installation and alignment of the roller tube and drive pulley system.
Instructions for proper placement and electrical connections of the control box.
Procedures for adjusting limit switches to ensure correct door travel and stopping points.
Steps for installing and aligning internal and external photoeyes for safety operation.
Guidance on setting up the breakaway detection system for enhanced safety.
Explanation of PLC inputs and outputs for diagnosing operational issues.
Definitions and solutions for common issues across various door components.
