Rittal PDU metered Series User Manual

Rittal PDU metered/metered plus/switched/managed 29
EN
 Use the "Down" key to select the DHCP setting "OFF" and
press the "Return" key to confirm your selection. The first page
of the IP v4 Setup menu for setting the IP address will appear.
 In the same way as you entered the PIN, enter an IPv4 address
permitted in the network and confirm with "Return".
 Press the "Down" key to move to the page 2 of the IP v4 Set-
up menu.
 If necessary, amend the subnet mask to the required setting
and confirm with "Return".
 Press the "Down" key to move to the page 3 of the IP v4 Set-
up menu.
 If necessary, amend the gateway to the required setting and
confirm with "Return" to save the altered network settings. The
new network settings will be displayed.
 Connect the PDU to your Ethernet LAN with a network cable
(fig. 12, item 9).
Settings of the PDU

Rittal PDU metered Series Specifications

General

Brand	Rittal
Model	PDU metered Series
Category	Power distribution unit
Language	English