6 Owner’s manual | Remedy III adjustable bed
6
4
Installation guide
NOTE: For safety reasons, lifting of the adjustable bed must always be performed by two (2) people; and
the unit should always be on a flat surface before opening. Check to make sure that all power cords are
clear and do not interfere with any adjustable bed mechanisms.
Setting up your adjustable bed
Unfold the base. Keep the top side facing down.
Plug the input power cord into the power supply.
Connect the power supply to the control box, which is the black box attached
to the bottom of the bed.
Assemble the legs using any combination of the 8", 3", and 2" leg sections to
choose your bed's desired height. All legs must be the same height.
Attach the legs to the adjustable bed using the pre-drilled holes on the frame.
Do not over tighten.
Next, the remote controls will need to be paired to the bed. Put the included
AAA batteries into the battery compartments on the remote controls.
Find the pairing button on the control box on the underside of the bed.
Method 1: Plug the power cord into the wall outlet, then press and hold the
pairing button for three seconds. A light will flash quickly to indicate the bed
is ready for pairing. Within fifteen (15) seconds, press and hold the head up
and foot up buttons on the remote control simultaneaouly for three seconds.
A short beeping sound along with the backlight of the remote control flashing
will indicate the remote has been paired.
Method 2: Unplug and plug in the adjustable base again, the light will flash
quickly on the control box. Within fifteen (15) seconds, press the head up and
foot up buttons on the remote control simultaneously. A short beeping sound
along with the backlight of the remote control flashing will indicate the remote
has been paired.
Repeat above steps to pair second remote control.
NOTE: Please unplug the bed before completeing this step. With two people,
carefully lift the adjustable bed and set it in place upright on its legs. Excessive
pressure may damage the legs. Remove all protective plastic covering.
Insert mattress retainer bar into the two holes at the foot end of the bed.
Plug the powercord into a grounded electrical outlet. A surge protector (not
included) is recommended. Verify that the bed is operational by using each
function on the remote.
3
2
1
With two people, carefully lift the bed base out of shipping carton and place it
flat on the floor with the top side facing downward.
4
5
6
7
8
9
10
11
6 Owner’s manual | Rize Split adjustable bed
To Next Page
Loading...
