RJS Inspector D4000 - 5.2 Scanning

To Next Page

To Previous Page

Operator’s Guide Inspector D4000™ Auto Optic

002-5564 RJS, Minneapolis, MN

5.2 Scan

After finishing calibration press Select and Enter at the

same time; the “Ready Menu” will display:

Scan Calib Setup

Storage Inactive

D4000A Ver x.xx

In addition to CALIB, explained in the previous section,

there are 3 additional “selectable” functions: Scan,

Setup and Storage:

 Press Select to choose an option.

 Press Enter to initiate processing for that option.

Select Scan (from the Main Menu) to display the initial

Pass/Fail Analysis screen for the previously scanned bar

code.

Note:

A bar code can be scanned at any time except when the

unit is printing

Other manuals for RJS Inspector D4000