Operator’s Guide Inspector D4000™ Auto Optic
002-5564 RJS, Minneapolis, MN
On the previous tables, all ISO/ANSI symbologies use the
traditional specifications for bar width deviation.
X and Y represent the magnification range selected for
UPC/EAN tolerances.
Table 8-B (Code Identifier Descriptions for Pass/Fail
Analysis Screen)
B-1 Code 39; B-1 sub-specification for AIAG
B345 Code 39; B3, 4, 5, or 10 sub-specification
for AIAG
LOG Code 39; LOGMARS sub-specification
HIBC Code 39; HIBC sub-specification
3 OF 9 Code 39; Traditional ISO/ANSI
sub-specification
39+C Code 39; with Mod 43
25+C Interleaved 2 of 5with Mod 10
I25 Interleaved 2 of 5
CC Interleaved 2 of 5 ITF-14
sub-specification
GS1 GS1-128 Code 128
C128 Code 128
UPCA UPC version A
UA+2 UPC version A plus 2 digit addendum
UA+5 UPC version A plus 5 digit addendum
UPCE UPC version E
UE+2 UPC version E plus 2 digit addendum
UE+5 UPC version E plus 5 digit addendum
EAN8 EAN 8 character
E8+2 EAN 8 plus 2 digit addendum
E8+5 EAN 8 plus 5 digit addendum
EN13 EAN 13 character
13+2 EAN 13 plus 2 digit addendum
13+5 EAN 13 plus 5 digit addendum
To Next Page
Loading...
