5.14 Note
For safety reasons, it is best to turn off the receiver power before shutting off the transmitter.
Please do not disassemble the transmitter without permission.Unauthorized disassembly is not guaranteed.
This product is not a toy and is suitable for the player of 15+ years old.
5.13 Channel settings
Channel Reverse Setting:
Enter this setting interface through “Channel”--> “Phase”.
Each channel can be set to normal or reverse mode.
Channel Travel Setting:
Enter this setting interface through “Channel”--> “Range”.
The maximum and minimum travel of each channel can be adjusted.
Channel Fine tuning Setting:
Enter this setting interface through “Channel”--> “Fine tuning”.
The neutral point of each channel can be fine-tuned.
Channel Mapping Setting:
Enter this setting interface through “Channel”--> “Remapping”.
The buttons of CH3-CH8 channels can be customized per personal’s favor.
Channel Button Definition Setting:
Enter this setting interface through “Channel”--> “Btn Defin”.
Define the button control mode for SWA / A / B / C /D Channel.
Channel
2 / 5
Phase
Range
Fine Tuning
Remapping
Btn Defin
Enter the Timer setting interface through “System”--> “Timer”.
The maximum timer is 60 minutes.
Press the throttle trigger or direction stick to start the timer function.
During the timing process, you can long press the scrollwheel button to pause, long press again can press
clear the timer.
5.12 Timer
Timer Setup
State
Maximum
Trigger
Lap Time
ON
1min
THR
OFF
System
System
Joystick
Timer
About
Reset
5 / 5
- 11 -
To Next Page
Loading...