Rlaarlo CT-8A - Basic Function Introduction

5.2 Basic function introduction
Interface: Model
Select
Copy
Name
Reset
Total 8 groups to store the model data.
Rename each group.
Copy the model data to another group.
Reset the set model data.
Interface: Channel
Phase
Fine Tuning
Range
Remapping
Set the operation reverse for each channel.
Adjust the Max. and Min. travel for each channel.
The neutral point of each channel can be fine-tuned.
Btn Defin
Define the button control mode for SWA / A / B / C /D Channel.
The buttons of CH3-CH8 channels can be customized per personal’s favor.
Interface: MIX Setup
Direction
Linearity
Program
ESC Setup
This mixed control is mainly for CH1 and CH2, total 4 types of mixed control mode to select.
This mixed control is mainly for Channel A / B / C / D, called Winch Mode.
Set the throttle Curve, Brake Curve, direction Curve.
Servos Set the servo frequency and servo angle.
Delay the response to the ESC, with a maximum delay of 2.5 seconds for the throttle; activate and deactivate of the throttle
cruise speed function.
Interface: Radio
Pairing
Control
Fail Safe
Postback
2 code match pairing methods, wireless transmission of transmitter can be on / off.
Under Fail Safe Protection Mode, connect the receiver first, can reset the runaway value for each channel, the default value
is in the central position.
Adjust the sensitivity and direction of gyroscope.
Training Connect 2 same transmitters with Type-C data cable, set the role as coach or student.
Adjust the value of low voltage Alarm, correct the battery voltage.
Interface: System
System
Timer
Joystick
About
Adjust the CH1 direction stick / CH2 throttle stick on the Max. and Min. position, and then back to the central position.
The max. timer is 60 minutes, it can start by controlling the throttle or direction stick. Under timer, long press the scoll
wheel can pause or quit from timer function.
Reset Restore all parameters of this transmitter to original factory settings.
Scan the QR code by phone to learn from the videos; flip down the new page you can review the device information.
The battery type of the transmitter can be selected; the default automatic shutdown time of the transmitter is 15minutes;
turning on the setting lock can lock all setting functions.
- 5 -