RMS FREEDOM60 - Antibiotics Infusion Instructions; Prime Tubing; Flush

English 9 of 20
For Antibiotics Infusions, follow these instructions:
1 Turn ON 2 Loosen Cap
4 Turn OFF 5 Wind Knob
Watch for Drip
& Tighten Cap3
Prime Tubing:
Flush:
Always follow your provider’s protocol.
1 Clean Valve 2 Attach Flush
3 Open Clamp 4 Flush
Turn the syringe driver’s ON/OFF
switch to the ON position.
Loosen the cap on the RMS
Precision tubing set.
Turn the syringe driver’s ON/OFF
switch to the ON position.
Turn the syringe driver’s ON/OFF
switch to the ON position.
When medication starts to
drip, tighten the cap on
the tubing.
Follow your providers
instructions to dis-
infect your valve using
an alcohol pad or dis-
infection cap. Avoid
touching disinfected
opening of the valve.
Connect the
syringe directly
into the valve
and turn
clockwise.
Open the clamp
on the access
catheter and/or
extension set.
Flush with a
gentle push
and pause
method.