continued from preceding page
• …the pins are fully seated in the fuse socket and not touch-
ing each other;
• …the wiring is properly connected to the back of the switch;
• …there is a properly-installed fuse in the FuseMaster har-
ness and that it is not blown; and
• …the fuse socket adaptor (if used) is seated in the socket
and the spade connectors are properly attached.
Engine
compartment installation
If the fuse to be removed is located in the engine compart-
ment, you will drill the access hole in the fuse box cover. De-
pending on the particular vehicle, you may drill the access
hole directly over the fuse or at a top side corner.
With this exception, follow the instructions above.
To Previous Page
Loading...
