RoadRunner D4+ 4.0 - Parameter Settings (P-Settings)

9
Parameter Settings (P-Settings)
To make changes to any P-settings, press the power and mode buttons
simultaneously until the P-settings appear. Once the selected settings appear,
quickly press the power button once to proceed to the next P-setting. Press the
power button to exit the current P-settings or to advance to the next P-setting. P-
settings will automatically exit if there is no activity for 8 seconds.
Example: to modify KM vs. miles, press the power and mode buttons
simultaneously until the P-settings appear to enter P1. Once the selection
flashes, press the power button once to select 0 (KM) and once more to select 1
(miles). Once you’ve made your selection, press the power button to proceed to
the P2 setting.
P01
Headlight Brightness 1-3 3= brightest default is 3
P02
Range units: 0= Km, 1 = mile Default is Km
P03
Voltage: 24V,36V, 48V, 52V Default is 52V
P04
Automatic Display Shutoff Default is 5 minutes
P06
Wheel Diameter: 10.0 inches Do not change
P07
Magnetic Poles in hum motor: 30. Do not change
P08
Max output (max speed): 1 – 100% (example: 80 = 80% top
speed.
P09
0 = non-kickstart; 1 = kickstart. With kickstart setting on, the
scooter must be moving at 2mph for it to accelerate
P11
EBS Brake Settings: 0= EBS off 1= weakest EBS 5 = strongest
EBS (most sensitive). Default: 3
P12
Start Settings: 1 – 5; 1 = slow start 5 = fastest start
P15
Voltage cut off. When voltage drops below 42V, the scooter will
power off automatically to protect the lithium-ion battery.
Do not change
P17
Cruise control: 0= Non-Cruise 1 = Cruise
P20
Default = 4 Do not change