RS5 OWNERS MANUAL
17
Parameter Settings (P-Settings)
To make changes to any P-settings, press
the power button quickly three times in row.
Once the selected values begin flashing,
quickly press the power button just once to
cycle through the options. Press the power
button to exit the current P settings or to
advance to the next P-setting. P-settings
will automatically exit if there is no activity
for 8 seconds.
Note: * Do not change P-settings: P2, P3, P4. These are preset factory
settings and will disrupt the performance of your scooter if changed.
P1 KM/Miles setting; default is miles
P2* Voltage level setting (36V, 48V, 52V, 60V, 72V);
default 52V. DO NOT CHANGE
P3* Wheel diameter, in inches; default 10. DO NOT
CHANGE
P4* # of magnetic poles for speed measurement,
1-100 default 30. DO NOT CHANGE
P5 Cruise selection (0 means no cruise, 1 means
cruising). default 0
P6 Zero startup (0) vs. non-zero startup (1) settings.
When powering on, no icon will be displayed if
zero startup; the display will show “NON” if zero
startup. In non-zero startup mode, you will need
to manually bring the scooter to 3 MPH and
press the accelerator to start. default 0
P7 Speed limit setting, 1-100% default 100
P8 Sleep time setting, 1-60 minutes default 5
PA Start strength setting, 1-5 (1 least starting power,
5 strongest) default 1
PB Brake strength setting 1-5 (1 least stopping power,
5 strongest) default 1
Example: to modify
KM vs. miles, press
the power button
quickly three times
in row to enter P1.
Once the selection
flashes, press the
power button once
to select 0 (KM) and
once more to select 1
(miles). Once you’ve
made your selection,
press the power
button to proceed to
the P2 setting.
To Next Page
Loading...
