RX7 OWNERS MANUAL
22
Parameter Settings (P-Settings)
To make changes to any P-settings, press the
power button quickly three times in row.
Once the selected values begin flashing,
quickly press the power button just once to
cycle through the options.
Press the power button to exit the current P
settings or to advance to the next P-setting.
P-settings will automatically exit if there is no
activity for 8 seconds.
Note: * Do not change P-settings: P00, P01, P02. These are preset factory
settings and will disrupt the performance of your scooter if changed.
P00* Wheel diameter, inches; default 11
P01* Voltage level setting: 72V
P02* # of magnetic poles for speed measurement,
1-100; default 30
P03 Display reset
P04 KM/Miles setting; default is miles
P05 Non-kickstart (0) vs. Kickstart (1) settings. In
kickstart mode, manually bring the scooter to a
speed of 3 MPH, then press the accelerator to
start. default 0
P06 Cruise control (0 = non-cruise control, 1 = cruise
control); default 0
P07 Take-o strength setting 0-2 (0 least starting
power, 2 strongest); default 1
P08 Speed limit setting (speed governor), 1-100%;
default 100
P09 Brake strength setting 0-2 (0 = EBS lowest, 1 =
EBS strongest); default 1
Example: to modify
KM vs. miles, press
the power button
quickly three times
in row to enter P1.
Once the selection
flashes, press the
power button once
to select 0 (KM) and
once more to select 1
(miles). Once you’ve
made your selection,
press the power
button to proceed to
the P2 setting.
WATCH THE HOW TO VIDEO NOW
To Next Page
Loading...
