7
Product Use & Care
Macroboom Bluetooth speaker is intended to be used both indoors and outdoors.
The speaker has been tested to IP67 waterproofing standards. IP67standard allow
Macroboom to be submerged in water up to 1 metre water for 30 minutes without
any damage. However, Macroboom is not intended for constant underwater use.
Close the Cap properly before use (see Locking Back Panel Cap). If Macroboom is
placed in water without the cap properly closed, water may enter into Macroboom
and void warranty.
Always make sure the back panel cap is clean, free of any debris and correctly fitted.
The speaker will only meet IP67 ratings if all rubber seals and cap are properly locked
& sealed. Macroboom when incorrectly fitted and the USB cables are NOT
waterproof.
If you notice a muffling of audio after submersion, gently shake Macroboom to clear
excess water. If your speaker is exposed to salt water clean it thoroughly after use
with fresh water. Do not apply excessive force to any surfaces of Macroboom when
wet or in a wet environment.
Avoid prolonged exposure to ultraviolet radiation (UV) sunlight or magnetic fields.
Check the rubber seal periodically for premature wear and clean Macroboom with a
soft moist cloth and ensure no objects such as dirt, hair, sand are on the rubber seal
ring. Do not use any oily solvent or chemicals for cleaning.
Safety & Warning
Do not attempts to charge Macroboom when it is wet or you suspect water has sip
into Macroboom. Dry Macroboom and make sure all connections are dry before
attempting to open the Back Panel Power Switch & Connection Functions cap for any
connection with the USB cable or power source. Failure to do so may result in
electrical shock, fire or electrical damage to Macroboom and may void the warranty.
To Next Page
Loading...