Picture 2
bracket
235mm
110mm
55mm 55mm
505mm
65±2mm
35±2 mm
Stop block
for bracket
A812
A812
380
520
430
Picture 1
Ceiling
6
0
0
-8
0
0
mm
6
5
0
-
7
5
0
m
m
8
0
0
-9
0
0
m
m
Drawing panel
10mm
Ceiling
Removable panel
Removable baffle
6
0
0
-8
0
0
mm
6
5
0
-
7
5
0
m
m
8
0
0
-
9
0
0
m
m
10mm
(Picture 1-1 installation without removable baffle) (Picture 1-2 intallation with removable baffle)
Decorative panel
Picture 3
wall
Installation size on the ceiling (mm)
Size in the brackets is specific to A608 hood.(Unit: mm)
Range hood
Projection size
Duct hole sizeφ200mm
吸油烟机
Range Hood
A812
Installation
●Install bracket
D
rill four 60-70mm-deep holes by Φ8mm drill bit at positions corresponding to the hanging plate dimension.
Force the expansion tube into the holes and fasten firmly the hanging plate by the supplied four 4×60
wooden screws. Drill a 50-55mm-deepΦ10mm hole at position 65mm high from the four holes and force the
M6 metal expansion tube into the hole.(picture 2)
Adjust the drawing panel
Pull the brackets of the panel up to an appropriate height and then pull the panel sides to find the drawing
panel. Remove the protective film, and insert it along the gap between the decorative panel and the housing.
Then adjust it to the proper height.
●
4
● 650
2
3
650
Location:Reference dimension for installation of removable baffle is (mm),but subject to adjustment
according to actual situations. The installation hole(picture ) shall be centered vertically with the hood body and
kept horizontally.
Please see picture for the installation size on the ceiling.
Operator shall install range hood upright the gas hob with recommended lowest height between hood bottom
and cooktop is mm (if maximum installation distance is specified in the instruction of installation, this shall be
taken into consideration;
The installation height can be reduced according to actual situations when there is electric hob).
Mounting hole
of the drawing
panel
ST4X18 self-tapping
screws
895(600)
520
447.5
111
To Next Page