吸油烟机
Range Hood
3
Installation
War ni ng
Preparation
Notice
1.
2
The range hood is prohibited from exhausting fume into hot flue , which is used for exhausting gas fuel or other
fuel fume.
.When installing metal expansion tube, ensure perfect match of tube diameter with hole diameter to prevent
accidental falling off from loosened expansion tube due to excessive hole expansion.
3.Please keep good ventilation in the room when range hood is working as while as and gas or other fuel combustion .
4.If flue outlet is smaller than air duct, or the air duct is too long, the absorbing will be affected.
5.This product is only used in the home daily. Don’t use it in the special environment (such as outside), or exhaust
dangerous or explosive air. Please put hood in the dry, good ventilation or safe environment before installation.
●
●
1. 2. 3 4
Ambient environment
Range hood shall be installed away from positions with too many windows or doors, which will lead to strong air
convection and thus reduce the effect of fume removal.
Tools：Installing range hood requires the following tools:
impact electric drill( with drill bit); Wrench; .Screwdriver; .Ruler
●
●Don' t connect electricity before installation avoiding from electric shock.
●
●
●
●
●Don' t install range hood too high or disturbed by air. It may reduce absorbing effect.
●Please keep enough space when installing kitchen cabinet so as to maintain and repair.
●Please keep hood parallel when installation.
● Please keep earth well. (It’s dangerous to connect hood with water pipe or gas pipe, it may cause fire or
explosion).
●Pleae use appointed accessories to install hood or it may fall down.
●If wire is broken, only manufacture, appointed service department or other professional engineers to
change it. Don't change,stretch ,press or bind wire, or it may cause wire destroyed, fire or electric
shock.
Installation and circuit setting must be done by experienced professionals. Non-professionals are not
allowed to install, dismantle and repair the hood.
Do not expose the hood if your kitchen is under renovation, because construction materials, dusts, paint,
coatings, and emitted gases will corrode and tarnish the hood surface. Therefore, it is recommended to
install it after the renovation is completed.
Don' t install the hood on wood and other combustible walls. The wall shall be made of noncombustible
materials with enough strength.
The hood may have very sharp edges. So, please wear protective gloves during hood installation, cleaning
or repair.
Please be care of electricity inside of wall when operator digging holes on the wall. It may causes fire.
To Next Page
Loading...
