HEAT LAMPS
The heat lamp globes in these appliances are specifically designed and
manufactured for Roband food bars. Each lamp globe is rated at 250W, 230V. The
lamps are controlled by a simple rocker switch.
IMPORTANT: The heat lamp assembly should be powered on DURING and AFTER
operation of the food bar. Otherwise, steam from below the lamp assembly may
condense on the lamp components, creating the potential to cause an “arc” or “short”.
This arcing may damage the heat lamp components. When the food bar is
switched off, the lamps should be left running for 10 – 15 mins to allow all the
steam to evaporate, removing the potential for condensate to form on the lamp
components.
LAMP REPLACEMENT & INSTALLATION
1) Turn the unit off, unplug the machine and allow to cool to room temp before
replacing lamps. (If the unit is a fixed appliance, ensure power is disconnected).
2) Grip wire lamp cover/guard between thumb and forefinger on left and right
element guard bars. Squeeze towards the center to release the guard and let
the guard rotate down.
3) Remove new lamp from packaging and grip around large diameter of ceramic
end. Insert alternate end of lamp into ceramic terminal block, taking care to line
up Center Boss of lamp, with terminal Pin in terminal block.
To Next Page
Loading...
