Operating your radio - FM auto-tune
1. Fully extend the wire aerial located on the rear of your radio. Place
the wire antenna so that it is as straight as possible extending either
above or below the radio.
2. Press and release the On/Off button to switch on your radio.
3. Repeatedly, press and release the Mode button until the FM mode is
selected.
4. Rotate the Tuning control clockwise and then press and hold down the
Tuning control for 2 - 3 seconds. This will cause your radio to search
from low frequency to high frequency and to stop automatically when
it fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio may display the station name.
6. To fi nd other stations press and hold the Tuning control as before.
7. Rotate the Tuning control anti-clockwise and then press and hold
down the Tuning control for 2 - 3 seconds. This will cause your radio to
search from high frequency to low frequency and to stop automatically
when it fi nds a station of suffi cient strength.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting. To switch off your radio,
press and release the On/Off button.
13
4-7
2,9
3
9
Note: If you fi nd that FM reception is poor, try
repositioning the wire aerial. Place the wire antenna so
that it is as straight as possible extending either above
or below the radio for optimum reception.
If you fi nd that an FM broadcast has a lot of background
hiss, this may often be reduced by setting the radio
into Mono reception mode for the current FM station.
Please refer to the section 'Stereo / Mono setting - FM'
on page 17 for further details.
To Next Page
Loading...
