If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
16
Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
to also be able to fi nd weaker signals, possibly from more distant radio
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press and release the On/Off button to switch on your radio.
2. Repeatedly, press and release the Mode button until the FM mode is
selected.
3. Press and release the Menu button. The FM menu will show on the
display.
4. Rotate the Tuning control until 'SCAN' shows on the display. Press
and release the Tuning control.
5. Rotate the Tuning control to switch between 'LOCAL' and 'DISTANT'
options on the display. The Distant option will allow the radio to fi nd
weaker signals when scanning.
6. Press and release the Tuning control to confi rm your selection. The
radio will then revert to the normal information display. The Local or
Distant setting is stored in the radio and remains in force until changed
or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
4-6
1
2
3
To Next Page
Loading...
