46
System reset
If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press and release the On / Standby button to switch on your radio.
2. Press and release the Menu button.
3. Rotate the Tuning control (Tuning buttons on remote) until 'System
Setting' appears on the display. Press and release the Select button.
4. Rotate the Tuning control (Tuning buttons on remote) until 'Factory
Reset' appears on the display. Press and release the Select button.
5. Rotate the Tuning control (Tuning buttons on remote) until 'Yes' is
highlighted on the display. If you do not wish to carry out a system
reset, highlight 'No' and then press the Select button. The display will
revert back to the previous display.
6. With 'Yes' highlighted, press and release the Select button. A full reset
will be performed. The station list and presets will be erased. Alarms
will be cancelled and sleep timer settings will be set to their default
values. The display will show 'Welcome to Digital Radio' and the unit
will behave as when fi rst switched on (see page 6).
In case of malfunction due to electrostatic discharge, reset the product
using the above procedure. In some circumstances it may be necessary
to disconnect and then reconnect the mains power in order to resume
normal operation.
If a problem persists please refer to the guarantee section at the back
of this instruction book which explains how to obtain support for your
radio.
DAB
System Setting
<
<
System Setting
Factory Reset
<
<
Factory Reset?
No
<
<
Yes
2
3-5
3-6
To Next Page
Loading...
