Note: The information display will default back to DLS after 10 seconds
except when showing signal strength.
DAB Menu
When in DAB mode, press and hold the Info/Menu button to enter the menu.
Full Scan – Start a DAB scan to find new stations
Manual Tune – Allows tuning to a particular DAB multiplex/station
Prune – Remove DAB stations from memory that were not found on the
last scan
DRC – High/Low/Off dynamic range control – useful for listening in a
noisy environment. Leave OFF / disabled for normal listening
FM Operation
With the radio on, press the Mode button to select FM mode.
To search for a radio station, press the Tuner dial to scan for a radio station.
Note, if you turn the dial to the left, then press, the radio will scan DOWN in
frequency. Turn the dial to the right then press to scan UP for a station.
Press and hold the Info/menu button to enter the menu and alter the ‘scan
setting’. This allows you to shoose ‘Local’ or ‘Distant’. Setting to ‘Local’ will
cause the auto scan to only stop on stronger radio stations.
Radio text (RDS): Short press the Info/menu button to cycle through the
following information on the display (when it is available):
Radio Text – displays current radio program information
Programme Type – displays the genre
Frequency – displays the current frequency in MHz
Power source – shows whether USB or battery power is being used
Time – the time being broadcast by the radio station
Date – the date being broadcast
To Next Page
Loading...
