compartment)
Carefully extend the antenna fully to ensure good radio reception
Push the volume/power dial to turn the unit on.
IMPORTANT: Ensure that the USB power source is the correct
specification, 5V 1 or 2A output. Using a non standard USB power source
may damage the device.
When the Play 11 is switched on for the first time, the unit should perform a
DAB scan. This allows the radio to find stations available to allow you to tune
in.
DAB Operation
Ensure the playback mode is DAB (press Mode to choose DAB)
User the tuner dial to select a new station to listen to and press to select a
highlighted station.
Info: various information is available to view when listening to DAB. Pressing
the Info/Menu button briefly will cycle through the following information
items:
DLS – This shows current information about the radio program or song
currently being played
Signal strangth – shows a graphic that reveals the strength of signal.
Use this to place the radio in a good position for high quality reception
Programme type – shows the genre of the broadcast
Ensemble name – displays the multiplex that the radio broadcast
belongs to
Channel number/frequency – shows details about the radio singal
Signal error – shows the stability and quality of the radio reception
Audio bit rate – displays the audio quality of the broadcast
Power source – shows whether mains or battery power is being used
Time/date – displays the current time being sent by the broadcaster
To Next Page
Loading...
