12
3. Whilst the
1
real time symbol is flashing, set the
correct time by pressing the numbered buttons. As you
press each button the corresponding number will show
on the display.
4. Press the Enter button to complete time setting. If an
incorrect time has been set the radio will beep and the
ERR will flash in the display. Reset the correct time by
pressing the numbered buttons again.
Note:
a. Time can only be adjusted whilst the
1
real
time symbol is flashing in the display.
b. You may change from 24 to 12Hr clock mode using
the mode button as described later
1
4
5
6
12
3
7
M
8
0
9
C
Tuning
AM /PM M emo Scan M em o Del
Enter
Freq
Time Set
Manual/Auto
To Next Page
Loading...
