If a button is not pushed within 30 seconds the thermostat returns to
operation.
Use the or to change the hour
of the start time if desired.
Push EDIT SCHEDULE to move to minutes.
Use the or to change the minutes
of the start time if desired.
Push EDIT SCHEDULE to move to the heat or cool temperature setting.
Use the or to change the temperature setpoint.
Pressing will switch between cooling and heating. Use and
to change the setpoint.
- OR -
Push EDIT SCHEDULE to move from heat to cool or cool to heat
temperature setting. Use the or to change the temperature
setpoint.
NOTE: THE HEATING AND COOLING SETPOINTS
CANNOT BE ENTERED AS CROSSED. THAT IS, THE
COOLING SETPOINT CANNOT BE LOWER THAN THE
HEATING SETPOINT.
Push EDIT SCHEDULE and repeat this process for the remaining three
weekday settings. All of the week days will use this schedule.
After the weekday schedule is complete the display will show the
weekend schedule.
Continue the same steps to program the four weekend settings.
When you are finished, the thermostat will be in operation after 30
seconds.
To Make Changes to the Settings
When and are pressed at the same time the thermostat will
display the current settings in order.
To change any setting:
When the setting is visible and flashing press the or
arrows to adjust the number on the screen.
To exit the changes and save:
press START/STOP SCHEDULE. The thermostat will return to
operation.
SCAL = Scale in °F (Fahrenheit) or °C (Celsius)
7
To Next Page
Loading...
Need help?
General
