Robin EH18V OHV - Page 26

Step
16
-
17
Part to remove
Cylinder
Cylinder
head
Procedures
(1) Remove cylinder baffle.
M6X8mm bolt
*.-- lpce.
(1) Remove rocker cover and guide plate
from cylinder head.
M6
X 12mm bolt 4pcs.
screw.
M8 lock nut
- 2pcs.
to the flywheel side, remove rocker arms.
(See
Fig. 5-1 5.)
(4) Remove push rods.
(5) Remove cylinder head and gasket.
(2) Loosen lock nut for rocker arm adjusting
(3) Slide off rocker arm shaft from the holder
M8X65rnm
bolt 2pcs.
M8X40mm
bolt .--- lpce.
M8 flangenut
-.... 1 pce.
Remarks Tool
1 Omm box wrench
lOmm box wrench
12mm box wrench
12mm box wrench
Fig. 5-14
Fig. 5-15
-22-