Robin EH18V OHV - Page 36

5-4-7 MAIN BEARING COVER
(1) Install oil pump to the main bearing cover.
M6 X 12mm bolt .... 4 pcs.
8-9.5 N*m
80-1 00 kgcm
6-7 ft*lb
Lubricate the oil seal and bearing sur-
faces. Add a light film of
oil on the main
bearing cover face
to hold the gasket in
place.
Place spacers chosen at procedure 5-4-6
on crankshaft.
Use an oil seal guide when installing the
main bearing cover
to avoid damaging the
seal.
Tap
the cover into place with a soft ham-
mer.
Main bearing cover.
M6
X 30 mm bolt and washer -.-. 8 pcs.
Tightening torque
8-9.5 Nom
80-1 00 kgocm
6-7 ft*lb
CRANKCASE KEY
CRANKSHAFT
OIL PUMP (INNER)
0 RING
M6 BOLT AND WASHER
ASS'Y
... ~Pcs.
OIL PUMP COVER
M6 BOLT ". ~PCS.
Fig. 5-33
-32 -