Order
Procedures
It
em
I
Remarks
Tool
9
10
Starting pulley
,
Flywheel
(1)
Remove the starting pulley from the
fly-
wheel.
144
nut:
1
pce.
Fit
a box or socket wrench over the fly-
wheel
nut,
and strike
it
hard with a ham-
mer
to
remove the 14
mm
nut and spring
washer.
(1) Remove the flywheel from the crankshaft.
Fig.
16
Be careful to damage
and the like.
wheel with a driver
or socket wrench
the blades of the fly-
19 mm box spanner
(See
Fig. 16.)
wise with
a
hammer.
Strike counterclock-
Fit
the flywheel pull-
er
as per Fig.
17,
turn
the center bolt clock-
wise
and
pull out the
flywheel.
I
Flywheel
Puller
0
'
Flywheel
Fig.
17
Order
Tool
Remarks Procedures
Item
11
10 mm
box
spanner Sems bolt (1) Remove the ignition plug cap from the Ignition coil
ignition plug; and remove the ignition
coil from the crankcase.
12 19 mm box spanner
(1)
Remove the ignition plug from the cyl-
Ignition plug
inder head.
13
(1) Remove the
8
mm bolt and remove the
Cylinder head
cylinder head from the crankcase.
8@
x
40
mm bolt:
8
pcs.
(2) Remove the cylinder head gasket from
the crnkcase.
-
15-
To Next Page
Loading...
