Need help?Do you have a question about the Robin EY18-3 and is the answer not in the manual?
Details the wiring diagrams for starting systems.
Wiring diagrams for cell start systems.
Step-by-step procedures for disassembling engine components.
Steps for removing the cylinder head and spark plug, including torque specs.
Procedure for removing intake and exhaust valves using a compressor tool.
Steps for removing the main bearing cover and its components.
Procedure for removing the camshaft and tappets.
Steps for disassembling the connecting rod and piston assembly.
Steps for removing the crankshaft from the crankcase.
Detailed procedure for adjusting the breaker point gap for proper ignition timing.
Steps for adjusting the ignition timing using a timing light.
Guides for diagnosing and resolving magneto-related engine starting issues.
Covers common causes of incorrect fuel-air mixtures and maintenance.
Procedures for adjusting pilot screw and throttle stop screw for proper idling.
Lists common causes for engine starting problems, categorized by system.
Addresses issues related to fuel supply for starting difficulties.
Covers potential causes of starting problems related to engine compression.
Troubleshoots issues related to the ignition system causing no spark.
Identifies causes for engine misfiring or running rough.
Lists reasons why the engine might suddenly stop running.
Explains causes of engine overheating and how to prevent it.
Discusses causes of engine knocking due to detonation or poor fuel quality.
Identifies reasons for engine backfiring through the carburetor.
To Next Page
General
