Robland Z400 EL - User Manual

Z400-serie V0119 1
EnglishDeutsch
Index
Important instructions when ordering spare parts 2
Safety and maintenance instructions 2
Danger list 3
Operating instructions 3
Normal and prohibited use 4
REMAINING RISKS 4
Explanation of acoustic levels 5
General dimensions 5
Technical Data 6
Transportation and installation of the machine 7
Electrical connection 7
Mounting the sliding table 8
Starting the machine 9
Starting the machine version X1 en X3 10
Changing main sawblade and scorer sawblade 18
Use and adjustment of the riving knife 20
Lower sawblade cover 20
Adjusting the main sawblade and scorer sawblade Z400M 21
Adjusting the main sawblade and scorer sawblade (Z500EL and Z500X) 21
Blocking the sliding table 22
Mounting of the cross-cut table 23
Mounting of the cross-cut fence 23
Adjusting the cross-cut fence 24
Use of the parallel fence 25
Calibration of the scale on the parallel fence 26
Cutting with mitre fence 26
Mounting of the roller support option 27
Using the saw guard 27
RPM indicator lights 28
Belt tension and speed changing 29
Belt tension and speed changing scoring saw 29
Maintenance of the machine 30
Problems: causes and solutions 30

Summary

Safety and Maintenance Instructions

General Safety Practices

Covers safe work area, PPE, and general precautions.

Danger List

Mechanical Risks

Details various mechanical risks inherent in woodworking.

Operating Instructions

User Training and Machine Operation

Normal and Prohibited Use

Permitted Operations

Prohibited Operations

Lists forbidden tasks on the panel saw for safety.

Remaining Risks

Contact, Recoil, and Pinching Risks

Details risks from blade contact, recoil, pinching, and crushing.

Electrical Connection

Starting the Machine

Machine Start-up and Safety Precautions

Covers general start-up, emergency stops, and access door safety.

Starting the Machine (Version X1 and X3)

Initial Start-up and Reference Procedure

Describes the initial steps and reference procedure for X1/X3 models.

Entering Measurements and Axis Selection

Saw Blade and Groove Cutter Settings

Parallel Fence Calibration

Describes the process to calibrate the parallel fence scale.

Changing Main Sawblade and Scorer Sawblade

Sawblade Replacement Procedure

Step-by-step guide for changing blades.

Scoring Unit and Groove Cutter Mounting

Use and Adjustment of the Riving Knife

Adjusting the Main Sawblade and Scorer Sawblade (Z400 M)

Height and Angle Adjustment (Z400 M)

Adjusting the Main Sawblade and Scorer Sawblade (Z500 EL and Z500 X)

Height and Inclination Adjustment (Z500 EL;Z500 X)

Scorer Blade Alignment

Adjusting the Cross-Cut Fence

Use of the Parallel Fence

Calibration of the Scale on the Parallel Fence

Using the Saw Guard

Belt Tension and Speed Changing

Belt Tension and Speed Changing Scoring Saw

Maintenance of the Machine

Problems: Causes and Solutions

Basic Settings of a Panel Saw

Perpendicularity

Fence Alignment and Adjustment

Cutting Test for Perpendicularity

90° and 45° Setting of the Sawblade

Robland Z400 EL Specifications

General

Brand	Robland
Model	Z400 EL
Category	Power Tool
Language	English