ROBLIN Virtuose - Proper Use

Z
If the appliance is mounted
on flammable materials, the
guidelines and regulations
relating to low voltage
installations and fire prevention
must be followed strictly.
Z
For the fitted units, the
components (plastic materials
and veneered wood) must be
mounted with heat-resistant
adhesives (min. 100 °C): the
use of unsuitable material and
adhesives may result in warping
and detachment.
Z
The kitchen unit must have
sufficient space to allow for
electrical connection of the
device. Wall-mounted units
above the device must be
installed at a sufficient distance
to leave the space required to
work in comfort.
Z
The use of decorative
hardwood borders around the
worktop behind the device is
allowed, provided the minimum
distance always complies with
the indications provided in the
installation drawings.
Z
The minimum distance between
the fitted device and the
rear wall is indicated in the
installation drawing for the
flush-fitted device (150 mm for
the side wall, 40 mm for the
rear wall and 500 mm for any
wall-mounted units above it).
Z
To avoid any infiltration of
liquids between the hob frame
and the worktop, position the
adhesive seal provided along
the whole outer edge of the
hob before installation.
Proper use
Z
The suction hood has been
designed solely to eliminate
cooking fumes during domestic
use.
Z
Never use the appliance for
purposes other than those for
which it has been designed.
Z
Deep-fryers must be kept
under constant supervision
when in use: the oil may catch
fire if it gets too hot.
Z
Do not use the device with
an external timer or separate
remote controlled system.
Z
The device must never be
installed behind a decorative
door, to prevent it from
overheating.
Z
Never climb onto the device, as
this may damage it.
Z
Never place hot pots and pans
on the frame, as this may
damage the silicon seal.
33